Washer Smells Like Mildew, Rotten Eggs or Sewer? How to Fix It

A washer smells musty or like mildew when water and detergent residue sit where they cannot dry: the door gasket, the drain pump filter, the detergent drawer or the outside of the tub. A monthly clean-out and a door left open between loads fix most of these. A rotten egg or sewer smell is a different problem, and it is often your water or your drain rather than the washer.

Safety first: natural gas has an odorant added that smells like rotten eggs, according to the U.S. Energy Information Administration. If the smell could be gas, for example near a gas dryer or gas water heater, do not touch light switches or light anything; leave the house and call the gas utility or 911 from outside. Unplug the washer before you open the pump filter or reach behind it.

Why your washer smells: checks you can do yourself

1. Wipe the door gasket. On a front-loader, pull back the folds of the rubber seal, especially at the bottom, and remove hair, lint, coins and slime. LG recommends wiping it with an oxygen-based bleach and leaving the door open to dry, and wiping the gasket and door dry at the end of each laundry day.
2. Clean the drain pump filter. LG says a clogged filter leaves water in the drum, which leads to odor over time, and Samsung says a filter that is not cleaned regularly will cause odors. With the washer unplugged, put down towels and a shallow pan, drain the water through the small tube if there is one, then unscrew the filter and clean it. Samsung suggests doing this at least once a month or every 40 washes.
3. Pull and wash the detergent drawer. Whirlpool says to remove and clean it regularly, following your owner's manual. Wipe out the housing it slides into as well.
4. Run a cleaning cycle (see below).
5. Leave the door and drawer open between loads so everything dries.
6. Take wet clothes out promptly. Whirlpool says wet clothing left in the basket can lead to mildew, and odors in both the clothes and the washer.

Musty or mildew smell in a front load washer

Front-loaders get the worst of it because the door seals tight and the rubber boot holds a little water in its folds. Samsung says moisture or residue trapped in a dark place can promote mold and mildew, that the rubber door seal on a front-loader is especially good at trapping moisture, and that wiping the drawer, tub and seal with a dry cloth after each load helps. Top-loaders can smell musty too, usually from residue on the tub and in the drawer.

Too much detergent makes it worse. Modern washers use little water, and detergent that does not rinse away leaves a film for mildew to grow on. Whirlpool says to use only HE detergent and never more than the manufacturer recommends, and Samsung says never to fill past the MAX line in the drawer. LG notes that in cold water, detergent may not fully dissolve and can build up.

How to run a tub-clean cycle

Each brand names the cycle differently, and the steps vary by model, so follow your owner's manual and start with an empty drum. Here is what three brands say:

• Whirlpool: run the Clean Washer cycle every month with affresh washer cleaner or liquid chlorine bleach. Do not use thickened, easy-pour or no-splash bleach, which can cause excess suds.
• Samsung: for a mildew smell, empty the tub and run a Spin-only cycle to clear any water. Then pour liquid chlorine bleach into the detergent compartment up to the MAX line (not the bleach compartment) and start Self Clean, Self Clean+ or Pure Cycle right away. It takes about an hour on top-loaders and about four hours on front-loaders. Samsung's mildew guide then calls for a Rinse+Spin.
• LG: run Tub Clean once a month with a washer tub cleaner. If a musty smell is already there, LG suggests running it weekly for the first three weeks.

Use one product at a time. The CDC warns that household chlorine bleach can release chlorine gas if it is mixed with certain other cleaning products, so never combine bleach with another cleaner.

Leave the door ajar in Florida humidity

In a Jacksonville summer, a closed front-loader stays damp inside for a long time. Whirlpool, Samsung and LG all say to leave the door or lid open after washing so the drum and seal can dry, and Samsung says to leave the detergent drawer open too. If you have small children or pets, keep the laundry room door closed while the washer is open. Our Florida humidity maintenance checklist covers the rest of the house.

Washer smells like rotten eggs

A sulfur or rotten egg smell has three likely sources, and the fix depends on which one it is:

• The washer itself. Standing water in the pump filter or the bottom of the door seal can go foul. The cleaning steps above fix it.
• Your water. Run the hot tap at a sink. If the hot water smells the same, the washer is not the cause. The Connecticut Department of Public Health notes that a rotten egg odor only in hot water may come from a reaction with the magnesium rod in the water heater, and that homes on a private well can have hydrogen sulfide in the water itself. That is a job for a plumber or a water-treatment company.
• Gas. See the safety note above. If you smell gas, get out first and ask questions later.

Sewer smell in the laundry room

A true sewer smell usually comes from the plumbing, not the washer. The standpipe your drain hose empties into has a trap, a bend that holds water to block sewer gas. According to the South Davis Sewer District, when a drain is not used often, the water in the trap can evaporate, and once it dries out, sewer gas can escape indoors. If the washer has sat unused for a while, run a short rinse cycle to refill the trap.

If the smell keeps coming back, the district notes the cause may be a damaged trap, a blocked vent or a plumbing leak. A trap that will not hold water or a poorly vented drain is a job for a licensed plumber. While you are behind the washer, make sure the drain hose is not sealed or taped into the standpipe; Samsung and Whirlpool both say that connection should not be airtight.

Burning smell: stop the washer

A burning, hot plastic or electrical smell is not a cleaning problem. Stop the cycle, unplug the washer or switch off its breaker, and call for service; a motor, pump, belt or wiring connection may be overheating. If you see smoke or flames, get everyone out and call 911 from outside, as Ready.gov advises.

What usually fails

• Door boot. A torn seal, or one with mold that will not clean up, gets replaced.
• Drain pump or filter housing. Water that never fully drains sits in the washer and sours; see washer not draining or spinning.
• Drain hose or internal hose. A kink or clog holds standing water.
• Motor, pump or belt. The usual sources of a burning smell.

If you also find water on the floor, see washer leaking from the bottom.

What it costs in Jacksonville

The diagnostic is $79, and it is waived when you approve the repair. Washer repairs start at $179 plus parts, and a typical washer repair on a standard brand runs $200 to $400 all in, with premium brands higher. You get a written flat-rate estimate before any work begins, many repairs can be finished on the first visit, and every repair carries our 90-day parts-and-labor warranty. See our pricing.

Schedule washer repair or call (904) 561-4790 for same-day service across Jacksonville & the First Coast.